Lanyard / Hand Loop Installation

March 17, 2018

All Leica Disto’s are included with a lanyard / hand-loop to prevent an accidental drop.

To install the lanyard:

1. Locate the 2 small holes near the base on left or right side (some units have these on both sides).

2. Squeeze the small loop at the end of the lanyard and push it into one of the holes. You may need to work it back-and-forth slightly until it comes out the second hole. It is sometimes easier if you can remove the battery door.

3. Loop the entire lanyard through the small loop and pull tight.




Also in Support

Pythagoras Functions

March 17, 2018

Using the tripod, you can measure distances indirectly, horizontally and vertically. The Leica Disto calculates the result automatically for you from three measurements. Functions such as automatic minimum and maximum measurements help you to measure the right point.

Read More

Saving your favorite functions on the programmable keys

March 17, 2018

Read More

Disto Error Codes

March 17, 2018

Read More